Feiyu-tech FY-30A User Manual download pdf (Page 6)

Guilin Feiyu Electronic Technology Co., Ltd.

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn service@feiyu-tech.com

- 5 -

DIP Switch Function:

Switch

number

For

Factory

use only

Flight

Mode

Selection

Flight

Mode

Selection

Not

used

OFF

Always

OFF

position

Flight

Mode

Selection

Flight

Mode

Selection

Not

used

Blue LED

Continuous flashing

On Solid

Flight Mode Status

Auto Stabilization

3D Mode

Red LED

OFF

Aircraft is stationary but

Red LED Flashes

ON Solid

Status Indicator

Normal

Need to initialize the gyro/

moving

High Vibration Detected. Does not

meet system requirement.

Gyroscope initialization (re-setting):

Out of the box, the FY-30A has been fully initialized. However, if the following condition

occurs, resetting the gyro is recommended:

1. The device is kept unused for a long time.

2. There is a change in environmental temperature of over 30 degrees.

3. The red LED light flashes even when the aircraft is stationary.

Initialization / Reset Procedure

Install the jumper as shown in this picture:

Power-ON the FY-30A and keep it stationary for at

least 20 seconds. You will notice the red light blinks at

two different rates (or turns off). Re-setting of Gyro is

completed. Disconnect power, unplug the jumper and keep it in a safe place for future

use).

NOTE:

 Carry out this re-setting procedure only if the condition (above) occurs. It is not

recommended to regularly reset the gyro. It is not necessary.

 The stabilizer unit does not need to be in a horizontal position during initialization.

However, you must ensure there is no vibration during this process. If you suspect

OFF

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Feiyu-tech FY-30A User Manual Page 6

Comments to this Manuals

Related products and manuals for Accessories communication Feiyu-tech FY-30A