Feiyu-tech FY-Y6 User Manual download pdf (Page 5)

GuiLin FeiYu Electronic Technology Co., Ltd

GuiLin FeiYu Electronic Technology Co., Ltd www.feiyudz.cn E-mail: ser[email protected]

Page 4

Step 3: Welding (soldering) the frames to the bottom fuse plate

with the electronics.

To accomplish this you will need a small soldering iron aprox. 35w.

Plug in the soldering iron and while it is coming to temperature, gather your Rosen Core solder and

safety glasses.

With the soldering iron at temp. place the tip on the bottom fuse weld point, making sure that the tip

makes contact with both the frame and fuse weld points. Apply solder at this point, you will notice

that the solder will wik (Flow) smoothly and make a gusset. Make sure you don’t have a cold solder

joint. I needed, reheat the joint. Use caution as not to Over Heat the solder joints as this will cause

the metal to curl up and away from the contact point.

Follow this process for the remaining points.

Now remove the top Fuselage plate, this will gain you access to the weld points inside and between the

Frames.

Once inspected and sure that no cold solder joints are there. Connect a 3S Lipo Balance plug to the

plug on the bottom of the Fuselage.

You should have all the led’s lit and the bottom will light up White and will flash for a few seconds

then glow steady. If some of the led’s do not light , inspect all your weld points. You can also take a

Cross any two wire ,

change Motor rotation

welding

ESC

Fuselage with

Electronic

components

Magic cable

tie through

square groove

M3×25mm Pillar

1 2 3 4 5 6 7

No comments

Feiyu-tech FY-Y6 User Manual Page 5